How to improve computer boot speed graphics and text tutorial

A few days ago to assemble a mainframe, through the efforts to finally hit 9 seconds to boot! Today and you share this process and the joy of success after AH ~

　　First, the assembly (detailed steps here is not detailed, directly on the diagram plus configuration)

Configuration as follows: i7-4790k original box, Asus B85, Kingston 8g*2, Kingston 120GSSD, st1g, Asus GTX960 2gd5, aviation Jia 500W.

Second, hard drive preparation: The hard disk partition table into the GUID format (GPT partition)

Three conditions are required for a computer to boot quickly:

1, motherboard support UEFI

2, the System support UEFI (this time I choose WIN7 64bit installation version, customers are mainly used to do 3D home design, professional software in the Win7 compatibility better. As for how to make the installation version of U disk here is no longer to repeat, UltraISO is easy to handle. )

3, the hard disk must adopt GPT partition.

The first two are needless to say, and here's how to make a hard drive into a GPT partition.

u disk boot → enter win8pe→ boot diskgen→ select "Hard drive" → convert partition table type to GUID format and save

Three, BIOS setup

1, after the conversion of the partition table type reboot into the BIOS

2. Startup item →CSM (compatible support mode)

Open CSM: Open

Note: If it is English, it may be enabled for launch CSM.

Start Device control: Uefi only.

Note: Three options are obvious, the first is UEFI mode and legacy traditional pattern automatic recognition mode, the second is only legacy traditional mode, and the third is only UEFI mode. Of course, the third one.

　3, back to the previous step, select the security option

This is a new security mechanism introduced with WIN8, which is installed Win7 to change this to "other systems"

Note: If it is English, it may be OS ... or security or security boot is set to Disabled or other OS.

4, the device start order must be set to UEFI beginning of the item, the machine is set to UEFI mode of solid State drive

5. Save and exit

Four, insert the production of a good installation version of U disk (win7 64bit) → Press F8 into the startup option (as shown below) → must choose the UEFI mode of U disk startup.

V. Start to do the system

and the traditional mode of doing the system basically the same, just start to note that the installation system will require the creation of primary partitions and additional partitions, follow the prompts to do.

In this step we only need to create a primary partition and additional partitions, the other partitions into the system, through the management component of the hard disk to the remaining partition, or use Diskgen partition also can.

Six, into the system after the simple, loaded drive.

Optimized reboot, ok!9 second boot!

and the continuous boot several times are 9S, I feel good! Although written 6 steps, but remove the assembly, install the system, installation software, only need 3 steps on the OH ~ here to share the learning together, I hope to help!