How to install a netbook system

There are many netizens often use netbooks, but the biggest difference between netbooks and notebooks is that there is no optical drive, so this will cause a lot of users because there is no optical drive will not install the system, we can use U disk or SD card to start the way to replace the optical drive. The current netbook's motherboard has basically supported the USB boot mode, we only need to do some special U disk processing, at the same time the boot to start the order of the USB device priority to start. Master can consider the mass production of U disk (this method is a bit troublesome, but also easy to damage U disk). But there is a simpler way to do it without mass production. That is, the U disk Startup Disk Production tool will be made into a U disk Startup disk, and then began to use the U-disk system, nonsense not to say, the following but for everyone to introduce a U disk to the netbook how to install the system

First step: Preparation and precautions before making

1. Download a key USB disk installation system software: Immediately download a key USB disk installation System Tools (Note: Computer memory can not be less than 512MB; U disk capacity can not be less than 256MB;

2. Download the ghost system to your hard drive (note not to download to the U disk)

The second step: Install a key u disk installation system software to create a startup disk

After installation, double-click to open a key software, the picture below, insert Mobile storage devices, click the "one key to make a USB boot Disk" button and then start to make your startup disk

(Note before the operation of backup U disk important data)

Note: Because U disk system files are hidden, you will find that U disk space has not changed much. Please don't worry about not making a success at this time

Click to see the "make success" approach

The third step: System file download and put into

Will just download the ghost system, copy to your USB drive;

Fourth step: reboot, set USB as the first boot disk (hint: Please insert the U disk first, the boot set up the startup item)

Two common ways to set up:

The first type: Start the hot key directly into the U disk System, ( computer Bois in the USB mode Boot hotkey )

The second: The boot set bios, into the U disk system, (U disk installation system BIOS how to set up the USB start text tutorial)

The following figure is the BIOS interface:

Fifth step: Enter the U disk System boot Menu interface

System recovery in two ways, the first one is to restore the system in PE, the second is not into direct restore C disk

Today we use the first method to enter the PE recovery system: as shown in the following figure: Run WinPE

PE boot, the following interface will appear during the boot process, because the computer model is different, it may take 1-3 minutes to wait, do not worry

If your laptop has a blue screen when you start PE, check to see why the hard drive works, and if it's AHCI mode, you can turn it into IDE mode. After the exchange can again try to enter the PE.