How to install the win7 system tutorial on U disk

First step: Preparation and precautions before making

1. Download one key USB disk installation system software: Download 3.1 Professional Edition immediately (note: computer memory can not be less than 512MB; U disk capacity can not be less than 256MB;

2. Download win7 system to your hard drive (note not to download to U disk) win7 System recommended: http://www.upanok.com/ghostxp/

The second step: Install a key u disk installation system software to create a startup disk

After installation, double-click to open a key software, the picture below: Insert U disk click the "Refresh" button. Click on the Pull-down menu, select your USB drive, click on the "Start Making" button (as shown, 1.2.3 steps)

(Note that important data is backed up before operation)

Wait 2 minutes or so, there will be a hint of the following picture, you can eject your USB drive, and then insert the new

When you insert it again, you will be prompted to "make a success" and you will be able to use it at this time.

Note: Because U disk system files are hidden, you will find that U disk space has not changed much. Please don't worry about not making a success at this time

In addition to the 3.1 version, the other version after the direct opening of the U disk will be prompted to format the U disk, at this time, do not click OK, you can eject U disk reinsert can be.

Click to see the "make success" approach

The third step: System file download and put into

Will just download the ghost system, copy to your USB drive;

If not downloaded, please click the system download address: http://www.upanok.com/ghostxp/

Fourth step: reboot, set USB as the first boot disk (hint: Please insert the U disk first, the boot set up the startup item)

Two common ways to set up:

The first type: Start the hot key directly into the U disk system, quick check table: http://www.upanok.com/jiaocheng/60.html

The second: After the BIOS setup, into the U disk system, speed check table: http://www.upanok.com/jiaocheng/68.html

The following figure is the BIOS interface:

Fifth step: Enter the U disk System boot Menu interface

System recovery in two ways, the first is to restore the system in PE, the second is not directly restore the C disk (use method: http://www.upanok.com/jiaocheng/62.html)

Today we use to enter the PE recovery system: as shown in the following figure: Run WinPE

PE boot, the following interface will appear during the boot process, because the computer model is different, it may take 1-3 minutes to wait, do not worry

If your laptop has a blue screen when you start PE, check to see why the hard drive works, and if it's AHCI mode, you can turn it into IDE mode. After the exchange can again try to enter the PE.

Step Sixth: Enter the windowsPE recovery system

There are a lot of tools in PE

Today I chose a simpler tool to restore the system with Onekey (one-click installation of the Clone version system)

If you need to partition, Diskgenius graphical partitioning tool to use the method http://www.upanok.com/jiaocheng/61.html

Select the system files you want to recover (just the Win7 system you just downloaded) and click OK when you are finished, as shown below

Determine if the system is restored, as shown in the following figure: selection is

Note: If you can not find or open your system files with Onekey, please unzip your system files, and then use Onekey to try, remember the system file naming, please do not use Chinese naming

Restore the system, as shown in the following illustration:

Restart the computer after the restore is complete and reload.