CPU heatsink is used to heat the CPU, the radiator on the stable operation of the CPU plays a decisive role in the assembly of computers to buy a good radiator is very important, how to remove the CPU and installation of the radiator?
Removal and installation of CPU Heatsink
Disassembly steps:
The first step: first find the radiator 4 corners of the clip, the knob in the counterclockwise direction of rotation 90 degrees.
Step two: Lift the buckle up. When the 4 clips are lifted up, you can lift the heatsink up and remove it.
Installation steps:
The first step: first check the radiator on the 4 buckle knob is not kept in the figure shown in the position, if not, please rotate them clockwise until you can not rotate.
Step Two: Locate the 4 fastener holes around the CPU on the motherboard, and insert 4 clips of the radiator into the 4 holes.
The third step: to ensure that the lower end of the 4 fastener pins has been inserted into the main board of the fastener after the hole (can not be inserted further down), and then press down the knob, until you hear "click" a sound, it means that the fastener has been in place. After the 4 clips have been pressed down into place, this step is complete.
Fourth step: In the back of the motherboard to check the Radiator 4 clips are in place, must be 4 pins should be presented in this state of the picture (the middle of the latch is fully highlighted), only to show that already in place.