I will give you a detailed analysis of photoshop software to share with you the tutorial on removing messy hair with high and low frequencies.
Tutorial sharing:
(The main learning method is not exquisite about materials. You can use the portraits on the left below to practice the exercises. You can also find a portrait material on Baidu .)
Comparison chart
I have set the color of the photo in LR. Now I can open the picture directly in PS.
Copy two layers consecutively as shown in figure ①. The one above is named high frequency, and the one below is named low frequency. 2. Click the low-frequency layer and select filter-Blur-Gaussian blur. The value is generally 3-9. You can adjust the value based on the image. Here I chose 3.5. Next, select the high-frequency layer, Click Image-apply image, and a prompt box is displayed, as shown in the following figure. Change the layer to low-frequency, mixed mode to minus, scaled to 2, and compensated: 128. ④ Change the layer mode to linear light.
In this way, you can start to shave the hair, select the low-frequency layer, and use a repair tool to ring the place with hair to the side of the intact skin without hair. Because of the low-frequency processing color, the principle of high-frequency processing details (for specific reasons, Baidu) can be seen that ① after the repair tool is used, there will still be a black line. At this time, you can jump to the high-frequency layer, then use the repair tool to perform the same action. You can see in ③ that this will cause the hair to crash.
Next, we will repeat the same operation and switch between the low frequency and high frequency layers. The repair tool will drag the skin with hair to the place without hair. Please be patient and take a few minutes. Do not take care of the hair around your eyes and mouth for the moment. After this step is completed, we can see the following figure. We can see that the color on the face is uneven and there are some flaws. In this case, you can use the skin polishing plug-in: Portraiture opens the skin polishing plug-in the low-frequency layer. If the effect is not obvious, you can grind it several times more.
Finally, we can process the hair on our eyes and mouth. Print a layer, select the imitation stamp tool, opacity is 20%, PS: here remember the opacity should not be too high, would rather 1.1 points slowly. After this step is completed, the hair will be wiped out.
The above are all the steps of this tutorial. And then refine other details.
Put a repaired image at the end.
All right, the above information is the detailed analysis of all the content shared by the high-frequency and low-frequency tutorials for users of photoshop's software, you can see that the user here, Xiaobian believes that it is a very clear method to mess up the hair, then you can follow the tutorial above in the small series to try to solve the problem with high and low frequencies.
