How to reset a routed device back to factory settings

This morning found that ZS VPN broke, to reset the route, the results of the reset button, after a few attempts have not been successful. Later found to be in the power to press before the answer, specially log:

Reset to factory Default:

Reset to factory settings. This would erase all settings, including last firmware installed, upgrade the keys and any type of configuration. Check Point recommends exporting settings before a reset to factory settings. Can reset factory settings in the following ways:

The press and hold the reset button on the "back of" the appliance for seconds. The pwr/sec LED would blink red once pressed. Release the button once it stops blinking.

You can does another type of factory-setting reset by following this steps:
Unplug the power cord.
Hold the reset button on the back of the appliance.
Plug in the power cord while holding the button, until the pwr/sec LED blinks red steadily.
Press the reset button for 3 seconds.
Press the reset button again for seconds until the pwr/sec LED blinks red.
Reconfigure the appliance.

More Wonderful content: http://www.bianceng.cnhttp://www.bianceng.cn/Network/lyjs/