How to Set Up A vro of tietong broadband

Tietong broadband is a commonly used network device. How to set up a vro for tietong broadband (applicable to most tietong users) to set up a vro for tietong broadband is described in detail:

How to Set Up A vro of tietong broadband (applicable to most tietong Users)

Vro for iron broadband

Let's talk about my details first:

First of all, I have a desktop computer in my house. I use Dial-Up to access the Internet. It is iron Tong broadband.

Secondly, I am a laptop with a wireless broadband signal receiver. I want to install a router to access the Internet for free.

Once again, I bought a TP-LINK 54Mbps Wireless Broadband Router price RMB: 150)

The following describes the specific settings:

1. Connect the desktop computer and the router first; Connect the router and the cat; of course, both the cat and the router need power-on.

2. Open a blank web page on the desktop, enter 192.168.1.1 in the address bar, and press Enter. In the displayed dialog box, enter the user name, admin password, and admin. Click OK.

3. After completing the preceding two steps, the vro configuration page is displayed. Follow the steps below:

1. Click -- network parameters, click -- MAC address clone, click -- clone MAC address, and click -- save

2. Click -- set wizard, click -- next, click -- ADSL virtual dialing PPPoE), click -- next, and fill in the dial-up account name and password of the original desktop in the internet account and Internet password, click -- next, click -- next, and click -- finish

3. The third small step of the current step is not to mention it for the moment. It is recorded as "3" and "3)

4. Clear the NIC Number of the laptop or the MAC address of the laptop)

1. Click Start-run in the notebook, Enter cmd, and enter ipconfig/all in the pop-up dialog box.

2. Write down: "Physical Address ....... in "00-15-00-48-000069", "00-15-00-48-000069" is the network card number of my laptop. Your number and letter combination must be different from my laptop, but the format is the same. Just remember it)

5. Now go to step 3. 3.

1. Click -- wireless parameters, and click -- Basic settings,

Frequency: 11

Mode: 54Mbps802. 11g)

Enable the wireless function to enable SSID Broadcast

Enable Bridge

2. Fill in "00-15-00-48-000069" written in section 4 and 2) as follows

MAC address of AP1:

Click -- save

6. Select "Network Neighbor" for both the desktop and Notebook -- TCP/IP protocol in the property) "auto get IP Address" and "auto get DNS server address", and click -- OK

7. The above six steps have basically been set up. You should be able to access the Internet on both computers. If not, restart the two computers.