two Tplink routers setting the way to extend the coverage of wireless WiFi signals
First, we need to look at the information about the extended WiFi hotspot, including the WiFi name and WiFi password information. With the Tplink router as an example, you can find the WiFi name in the wireless Settings-Basic Settings Tab interface.
Then switch to the Wireless Encryption Settings tab, where you can find the "WiFi password", which is the "PSK key" in the figure.
Perform "Restore factory settings" for the router that extends the wireless WiFi hotspot. In this case, "tenda/' target= ' _blank ' > Tengda router" As an example, there is usually a button or a small hole labeled "Reset" in the back panel of the router, which is often used to restore the factory setting of the router.
When the wireless router resumes factory settings, it automatically creates the WiFi signal by default, and then uses the computer to connect to the WiFi network created by the wireless router and enter the WiFi password for the connection.
Then according to the label on the back of this router to get "Router IP address", using the browser to log in to the router's background web interface. Go to the Advanced settings interface, switch to the wireless settings-Wireless basic Settings tab, and select the Network Bridge (WDS) item.
In the "Working mode: Bridge (WDS) mode" section below this page, click the "Scan" button to scan the wireless WiFi signal around you.
After you find the wireless WiFi signal that you want to extend, select the wireless WiFi signal and click the Yes button in the "OK to connect to this AP hotspot" window that pops up.
When you click on the "OK" button, the window appears as shown, prompting you to change this wireless router WiFi name and clicking the "OK" button to complete the change operation.
Finally, using the computer to reconnect Wi-Fi hotspots created by this router, you can click the "Refresh" button in the wireless WiFi connection interface of the computer to find the corresponding hotspot (usually the more powerful wireless WiFi hotspot is the extended signal).
Enter this router again "Wireless Settings"-"Wireless encryption Settings" interface, reload set up the wireless network "security type" and "Password", click the "OK" button.
The best thing to do is connect to this wireless WiFi network, and after the connection is successful, the wireless WiFi hotspot is expanded (that is, the network Bridge) operation, the wireless WiFi hotspot is greatly enhanced.