the method of setting up wireless bridge in tl-wr840n router
To confirm the need for bridging the signal parameters, that is, the main router's wireless signal name, wireless password, the following only do this article for example:
Note: All of the operation of Wireless bridging (WDS) is done at the secondary router without setting up the primary router.
1, into the management interface
The computer connects to the LAN port or wireless signal of the secondary router and uses the tplogin.cn login management interface.
2. Enable Bridge application
Click application Management, as follows:
To find the wireless bridge, click Enter:
1. Start Setup Wizard
After entering the Wireless Bridging Setup Wizard, click Start settings as follows:
2. Scan Wireless Signal
Routers automatically scan peripheral wireless signals
3, select the main router signal
Select the primary router signal to scan and enter the wireless password for the primary router, and click Next:
Note: If the main router signal is not scanned, verify that the primary router is on, and try to reduce the distance between the primary and secondary routers.
4. Confirm Admin IP Address
The primary router assigns an IP address to the secondary router for subsequent management of the router, and it is recommended that you write down the IP address and click Next.
5. Set up the wireless password of the auxiliary router
Direct Click Next, as follows:
Note: You can set wireless parameters for a secondary router here, but you must remain unchanged if you want to implement wireless roaming.
Once again into the application management >> Wireless bridge, you can see that the bridge status is bridged successfully. As follows:
This wireless bridging (WDS) Setup completes, the wireless terminal connects the Zhangsan, the wired computer connects the main, the auxiliary router's LAN port to be able to surf the Internet. In the process of terminal movement, automatic roaming between main and secondary routers can be realized.