How to use word2013 to make three-wire table

The steps to make the three -wire table are as follows:

Step One: Open word2013

Step Two: Select the Insert tab

Step three: Insert a table with 4 rows and 6 columns

Step four: Select the entire table, select the "Border" icon, set the border without a frame line

Step Five: The effect is as follows:

Step six: By step 4, select borders and Shading

Step Seven: Set the width to "1.5 points"

Step eight: Then select the entire table, and then set the top and bottom borders respectively

Step nine: In this way, the two lines of the three-Line table are complete.

Step Ten: Set the border line width to 0.75 points by following the steps above

Step 11: The left mouse button starts with a cell in the first row and drags to the last cell in the line to select the first row

Step 12: Then right-click to set the bottom border

Step 13: This way, a 0.75-pound line appears below the first line, and our three-wire table is complete.