How Tplink routers set up static IP

Tplink routers to set up static IP methods

If your Internet access is static IP, that is, you to the Network service provider (telecommunications or netcom) to apply for the broadband is a fixed IP address, and the network provider to provide all of your extranet IP address information: including IP address, subnet mask (Subnet Mask), Gateway ( Gateway), and the DNS server address. Then you set up your router in the following ways:

"Physical Connection"

1, from the broadband line router WAN port, the computer using network cable to connect to the router's LAN 1-4 port

2, check the LED, the router is operating normally, the system led (SYS) flashing, WAN port LEDs and LAN port LED illuminated steady or flashing.

If the SYS lamp is illuminated steady or extinguished, it indicates that the router is faulted; LAN Port LED or WAN port led is not lit, please check the physical connection is good, such as no network cable or network cable and interface is bad; if the connection is normal but the LED is not lit, it may be a network cable problem, we recommend that you change the network cable.

"Set up the router"

1, in the browser to enter the router LAN port IP address, in the pop-up box correctly fill in the router's management username and password to enter the management page.

If the router is the default setting, its administrative address is: 192.168.1.1; user name and password are: admin

2, in the left box select "Network parameters" → "wan port settings", then in the right box in the "WAN connection type" Select "Static IP", in the appropriate column to fill in the IP addresses (IP address), subnet mask (Subnet Mask), gateways (Gateway), and DNS server addresses. The following illustration.

3, if the line operators to limit the use of routers, you can clone the operator's binding MAC address to the Internet. The following illustration.

After the setup is complete, you will be able to surf the Internet.