When I recently tried to change the interface of the Huawei s2300-52p switch from the previous trunk to access, the changes were unsuccessful and the error message was as follows:
650) this.width=650; "src="/e/u261/themes/default/images/spacer.gif "style=" Background:url ("/e/u261/lang/zh-cn/ Images/localimage.png ") no-repeat center;border:1px solid #ddd;" alt= "Spacer.gif"/>
[Zgk-bg-ethernet0/0/6]dis This
#
Interface ETHERNET0/0/6
Port Link-type Trunk
Port Trunk Allow-pass VLAN 2 to 4094
Loopback-detect Enable
#
Return
[Zgk-bg-ethernet0/0/6]port link-t
[Zgk-bg-ethernet0/0/6]port link-type Access
Error:please Renew the default configurations.
... ...
[Zgk-bg-ethernet0/0/6]undo Port Link-type Trunk
^
Error:too many parameters found at ' ^ ' position.
[Zgk-bg-ethernet0/0/6]undo Port Link-type
Error:please Renew the default configurations.
[ZGK-BG-ETHERNET0/0/6]
Regardless of configuration, you cannot change the port trunk to access
After this configuration is found, you can change the port:
[Zgk-bg-ethernet0/0/6]dis This
#
Interface ETHERNET0/0/6
Port Link-type Trunk
Port Trunk Allow-pass VLAN 2 to 4094
Loopback-detect Enable
#
Return
[ZGK-BG-ETHERNET0/0/6] undo Port Trunk Allow-pass VLAN all
Info:this operation may take a few seconds. Please wait for a moment...done.
[ZGK-BG-ETHERNET0/0/6] Port trunk allow-pass VLAN 1
Info:this operation may take a few seconds. Please wait for a moment...done.
[Zgk-bg-ethernet0/0/6]port link-type Access
[Zgk-bg-ethernet0/0/6]dis This
#
Interface ETHERNET0/0/6
Port Link-type Access
Loopback-detect Enable
#
Return
Success!
Go first to enable all VLANs through the port and then re-add the default VLAN 1 through, then you can change the port type!
This article from the "full of strokes, modest benefits!" "Blog, be sure to keep this provenance http://lanfenggo.blog.51cto.com/6322019/1886836
Huawei switch changes port from trunk to access error resolution