In-depth discussion on TP-Link wireless router settings

The TP-Link wireless router is still widely used. So I studied the settings of the TP-Link wireless router. These methods are not very familiar to general users, here is a detailed introduction. Now, more and more users share Internet access and use their own wireless routes to access the Internet. Wireless routes are cheaper, and wireless and wired routes can be used at the same time, here we will talk about the settings for using TP-Link Wireless routing.

1. Single-Stage TP-Link wireless router configuration: (access Ethernet bandwidth directly through this router)

This method is very simple. You only need to read the manual and know how your broadband can be accessed. There are generally three types: Virtual dialing, automatic IP allocation, and fixed IP (static ), then, follow the instructions in the instruction documents to go through the following steps:

1. Connect the LAN port of the route to the computer Nic, and set the IP address on the NIC to the same network segment as the route;

2. Open the browser, enter the IP address of the router, for example, 192.168.1.1, in the address bar, and open the settings page (enter the default password, for example, admin and admin );

3. Set network parameters: (using virtual dialing as an example)

① Internet access: ADSL virtual dialing (PPPoE)

② Fill in the information box: ADS account

Password: the login password provided by the carrier

③ Wireless parameter settings: you can set a password or switch;

④ The gateway of the lower-level wired online computer Nic is set as the IP address of the router (Note: it is not the IP address of the WAN port !) For example, 192.168.1.1;

DNS: the DNS address of the Telecom server.

⑤ All LAN ports and wireless networks can be used for Internet access.

If you use the other two methods to access the Internet, you must set the WAN port information.

Ii. Multi-Level TP-Link wireless router settings: connect to the Internet via wireless network in the LAN)

Open the TP-Link wireless router settings page, as shown in the preceding figure;

Set network parameters:

① Internet access: Ethernet broadband fixed IP (static ). If you use a server, you can select whether to automatically allocate IP addresses based on the server settings;

② Fill in the information box: IP Address: can be selected at will. (If the server is used and the server has allocation rules, follow the rules.) For example: 192.168.1.2

Child mask: 255.255.255.0

Gateway: the IP address of the upper-level router (the internal IP address of the server), for example, 192.168.1.254.

DNS server: the DNS address of the Telecom server, for example, 202.102.197.122 (different telecommunications data centers)

③ The Gateway of the lower-level computer Nic is set as the IP address of the router (Note: it is not the IP address of the WAN port !) For example, 192.168.1.1; DNS: the DNS address of the Telecom server.

④ Set Wireless Parameters for TP-Link wireless routers

⑤ All LAN ports and wireless networks can be used for Internet access.