1. Go to the uTorrent official website to download the Linux version. Utorrent-server-3.0-25053.tar.gz
2. Decompress $ tar-zxvf./download/utorrent-server-3.0-25-53.tar.gz
The folder utorrent-server-v3_0 after decompression
3. Run the utserver File $./utserver
Then an error occurs,
./Utserver: Error while loading shared libraries: libssl. so.0.9.8: cannot open shared object file: no such file or directory
4. If there is only one library file missing, we will install it. $ Sudo apt-Get install libssl0.9.8
5. run $./utserver again.
The following command is displayed:
Server started-using locale zh_CN.UTF-8
Using locale zh_CN.UTF-8
File not found during integrity check:./settings. dat
File not found during integrity check:./settings. dat. New
File not found during integrity check:./settings. dat. Old
File not found during integrity check:./settings. dat
File not found during integrity check:./settings. dat. New
File not found during integrity check:./settings. dat. Old
Total physical memory-1 Max disk cached 33554432
File not found during integrity check:./DHT. dat
File not found during integrity check:./DHT. dat. New
File not found during integrity check:./DHT. dat. Old
File not found during integrity check:./RSS. dat
File not found during integrity check:./RSS. dat. New
File not found during integrity check:./RSS. dat. Old
File not found during integrity check:./resume. dat
File not found during integrity check:./resume. dat. New
File not found during integrity check:./resume. dat. Old
IPv6 is installed
6. Do not exit the terminal. Enter localhost: 8080/GUI/in the browser/
Username: Admin, password Blank
7. Go to the uTorrent main interface.
8. The next seed file uses transmission by default. This is acceptable. If you want to use uTorrentProgramSpecify the seed.
9 successful