Installation oracle11g encountered a "No access to temporary location" problem, details are as follows:
INS-30131] Failed to perform setup validation of the initial settings required.
Reason-Unable to access temporary location.
Action-Make sure that the current user has the required permissions to access the temporary location.
Additional Information:
-The frame setup check on all nodes failed
-reason: The cause of the problem is not available
-Action: User Action unavailable failure node Overview Pc-20130618muam
-Unable to retrieve Exectask version from node ' Pc-20130618muam '
-reason: The cause of the problem is not available
-Action: User Action not available
Solution :
In my share to see if there is no C-disk sharing, if not, then
At the command line, enter: Net share c$=c:.
1. Fix the problem of C $ share first (by the above method)
2. Test the success of C $ share. The method is to play net use in CMD \\localhost\c$ failure would be like this ...: System error 53
The network path is not found. Success is like this: the command completes successfully.
3. If the 2nd step fails, check to see if the TCP/IP NetBIOS Helper service in the service is turned on, and if not, start it. Troubleshoot system error 53:
Error 53 occurs when using the command net Usenet use \\localhost\c$ and the network path is not found. I entered in the virtual machine: NET share command, found only one ipc$ (the original default sharing was closed), after a turn Baidu, found a solution:
Step one: Check the AutoShareServer and AutoShareWks registry values to make sure they are not set to 0. Click "Start → run" in turn, enter regedit, and press ENTER to enter Registry Editor.
Step Two: Locate and click Hkey_local_machine\system\current controlset\services\lanmanserver\parameters.
Step three: If the AutoShareServer and AutoShareWks DWORD values in the Lanmanserverparameter s subkeys are configured with a value of 0, change the value to 1
Reboot the computer and rerun the installation file to solve the problem.