Installation of Red Hat 6.5

1. I'm using VMware11. I don't need to talk about the details of using a virtual machine for installation. Most people should know how to install Red Hat 6.5. The actual page after turning on the virtual machine is the following page. .


Interface description:

Install or upgrade an existing system

install system with basic video driver

Rescue installed system

Boot from local drive

Memory test

2. Select the first item to install or upgrade the existing system and then: The meaning shown in the figure is whether to perform a self-test on the disk. Select Skip:



3. After skipping, the following interface is displayed: these next steps are OK. The language selection is Chinese Simplified or not selected, and the device selects basic storage.





4. After the next step, this step chooses to ignore all data, because you are installing the system fresh:



5. Set the host name and set the urban area. The next step is ok. I wo n’t talk about it here. The next step is to set a password. Theoretically, the password to set a complex password must meet the complex requirements. I wrote a simple password here. Prompt to skip the next step;



6. This step needs to select the last item, Create Custom Layout to create a custom layout. Here you can see the capacity of the hard disk, and then start partitioning. First, / boot needs to be allocated to 200M, followed by the swap partition. This swap partition means yours. The system can call the swap partition when the memory is not enough. This is generally twice the real memory. It is enough to give more than 8G of memory to the same physical memory, and then give the rest to /, and then format the next step is OK;




7. In this step, it is recommended to choose custom installation to choose the packages you need to install. It is recommended not to choose java development here, because in the production environment, it is uncertain what version of java you need to install. Here I recommend that you check the desktop full development On the development tools, if you want to do KVM, you are advised to check the full virtualization so that you can go directly into the package;


8. After installation, you can use it, and then reboot, you can use it;

This article comes from the blog "A little rookie who can't cook any more", please keep this source http://liliming.blog.51cto.com/10925034/1787567

Installation of Red Hat 6.5