Invalid Result Location Value/parameter solution

About MyEclipse The Struts2 configuration file is more than checked exception Invalid result location Value/parameter

Sometimes struts.xml configuration is not wrong, can run smoothly, and MyEclipse9 the above version is often a large lump error identification, the error message is

Invalid Result location Value/parameter

Search for a moment, the results are mostly reproduced a "skill", is directly right struts.xml then choose MyEclipse under the "removed all validater what the" It's the struts.xml file that removes all the checks, such as all the red forks and warnings.

But that's a little bit of a bad thing, if it's something else. such as syntax errors that do not conform to the constraints of the struts DTD, these will not be an error. So it's not a good way.

In fact, you can find a solution, MyEclipse certainly in the general validation of XML methods outside the special test of struts, find it, cancel off on the OK ...
Over here:

Remove the build more check, keep manual than check, so that when it is really necessary to provide the MyEclipse Struts2 than the test manually compared to take care of the