PS IPhone6 Plus Battery has a point is the tool to professional, such as screw tools than our household are only professional to open the phone, and the inside of the power cord and the motherboard is glued to the operation of everyone do not force too fiercely.
Step 1th: Get the following tools and parts--iphone6 batteries and iphone repair kits. Need to buy a new battery, a dedicated screwdriver, a pry piece, and a screen sucker.
The 2nd step: Find the phone charging interface on both sides of the two five-corner screws. Open the iphone 6 and you just need to unscrew the two screws.
Step 3rd: Turn off the phone and use the five-angle screwdriver in the kit to unscrew the screws. The screwdriver's head is small, but it matches the small screws at the bottom of the IPhone 6.
Step 4th: Use the suction cup to pull the screen above the home key. Hold the sucker at the top of the home key, the other hand holding the fuselage, and then pull out. You just need to pry the space between the screen and the fuselage enough to plug into a piece of plastic.
The 5th step: Pry out the screen with the pry piece. Starting with the homepage key, start around the screen 1.1 points up to pry.
Step 6th: Put the screen part up to 90 degrees, but do not exceed this angle. The top of the screen is still connected to the fuselage, so don't pull hard. As the picture shows, you can set up the screen up to 90 degrees.
Step 7th: Locate and unscrew the fixed screen connection screws. It's a good idea to remove the screen while removing the battery because the battery is fixed with glue and it can be a lot of trouble to remove it. Unscrew the screws on the protection cover and remove the protective cover.
8th step: Disconnect the screen connector. There are several connectors between the screen and the fuselage, and you can pick them out from your mouth with a small dial or a thin nail file.
9th step: Remove the battery connector protection cover. The battery connector protection cover is fixed by two screws, which are screwed down and removed from the metal protection cover.
10th Step: Disconnect the battery connector. There is only one connector between the battery and the circuit board, you can pick it up with a small dial or a thin nail file.
The 11th step: Use the hair dryer to heat the back cover, the glue to blow soft. The IPhone 6 uses a lot of glue to fix the batteries, and they need to be softened to take the batteries off. You can use the hair dryer to heat the phone back cover, to soften the glue. Do not use a higher temperature than this heating tool, to heat the still comfortable will take the phone in the hands of the degree.
12th Step: Use credit card or plastic dial slowly pry open the battery. You can use a bank card, a thin dial or a shorty at the bottom 1.1 points to pry open the battery. Avoid the portion of the top near the screen connector, because the connectors are also hidden underneath. In addition, do not take mobile phone parts when the fulcrum of the battery. Try to keep the glue on the chassis so you can reuse it later.
13th step: Connect the new battery, and fold the connector. If you don't have too much glue left, you can use ultra-thin double-sided glue to fix the new battery. The connector only needs a little bit of force to return to the slot, but the alignment position may be a bit cumbersome, it will take you some time. The original battery connector is folded down, so it is now the same. As shown, you can press it down with a small dial or a thin metal file.
Step 14th: Reconnect the screen connector and reinstall the metal protection cover of the battery and screen connectors. Connect the screen connector in the reverse order, starting with the connector at the top of the fuselage and then reinstalling the metal protection cover.
15th Step: Close the chassis, installation screws.
All right, finally, our IPhone6 plus battery method and on the complete demonstration of an article, we must be careful in the process of processing.
