Kingston ValueRAM Series memory new number sequence

At present, Kingston in the market memory mainly has two series of--valueram and the hacker God article. The following article focuses on the ValueRAM series. Kingston ValueRAM Series Memory number/model rules are executed from May 1, 2012 onwards.

When we get a piece of memory, the light is usually difficult to distinguish between its capacity and type, even if the number of pins on the gold finger is not the same, the position of the mouth is different. The reason is simple, if we do not often touch different types of memory, it is difficult to the golden finger width, speed and the position of the mouth to prevent the space, accurate corresponding to its type.

For non-professional professionals, the identification of models or numbers on the Memory tab is a simpler approach.

The place where the red arrow points in the figure below is the Kingston memory model.

When purchasing, a model is specified, and only the exact parameters are specified. If the model you requested is not the same as the actual receipt, you can request a replacement.

　　"Key Memory Content"

Remembering the following key parameter locations is very helpful for our memory model rules.

　　1. Speed

Following the KVR, the new version of the model rules using a high two-bit representation (1333, 13), the old is the digital full label (1333). Strictly speaking, this value is higher than the speed rate, or the effective rate.

　　2, module type;

Typically, the notebook memory module is of type S, or SODIMM, which is about half the length of the average desktop. Normal desktop is n.

　　3, CL value

CAS latency delay. That is, the lower the value of the memory, the slower the number of cycles from the time the register reads to the data, the more clocks that are actually waiting to be cached from the buffer. Typically, the higher the data rate, the greater the value.

　　4, capacity

The number behind the slash indicates the capacity.

Column:

Kvr16s11k2/16

At a glance, the data rate is 1600 (DDR3); SODIMM type; CL is 11 clock cycles; 16G. The S module type is preceded by an empty, representing a 1.5V voltage. The front of the slash is K2, which means two bars.

Kvr18r13d4/16kf

Data Rate 1866 (18). DIMMs with registers, with address/command parity and temperature sensors, which are typically used on servers. CL Value 13. 16G. The front D4 of the slash indicates a double row of 4 particles. The k behind the capacity indicates the Kingston (Kingston) particles.