Make your own shop chop or head stamp with fireworks

Always see someone else's picture of the lower left corner or the lower right corner has its own signature seal, shop seal, or simply use the seal to do head, envy, so recently also learned how to make the seal effect, quickly write a tutorial to share with you, hope to feel the rain traces of happiness slightly ...

One. First to download tools, rain is not used PS, because the software is too big and complex, I use fireworks, is the software 3 swordsman one, you can only download this, the other 2 do not download, version is MX 2004. Baidu to search a lot of, and itself is not very big.

Two. After downloading a good installation I will jump past do not say, registration is not very troublesome, online to get a registration code in the good, do not open its official website registration, because usually all the registration code does not pass.

Three. After registration, you can use pull. The following is a formal start to the tutorial. CC ~ haha ~

1. The top toolbar, "file"-"new", or the new icon below, click on it, as shown in the figure input Oh, pay attention to the red circle place, others can be by default.

2. OK later, a canvas will be produced, but this is just a canvas oh, there is nothing to export, with the canvas of course to start on the above pull. The second step is to draw a square on the top, which is the edge of the stamp.

3. Using the "Rectangle" tool in a row of tools on the left side of the software, any drawing of a rectangle on the canvas, do not worry about the ugly painting, just drag it, because after the painting in the following properties of the column can be arbitrarily adjusted, the specific value to see the figure below oh, remember to pay attention to the circle.