Making soft and dark purple wedding slices with Photoshop

Original

< small map view big picture >

Final effect

1, open the original material, create an optional color adjustment layer, yellow, green, green, white, neutral, black to adjust, parameter settings such as Figure 1-6, determined to use a black brush to wipe out the people's clothes, the effect is as Figure 7. This step turns the background color into a purple hue.

< map 1>

< map 2>

< map 3>

< map 4>

< map 5>

< map 6>

2, create curve adjustment layer, the blue adjustment, parameter settings such as Figure 8, the effect is shown in Figure 9. This step adds some light yellow to the screen.

< map 8>

< map 9>

3, create color balance adjustment layer, shadow, midtones, high light adjustment, parameter settings such as Figure 10-12, the effect is as Figure 13. This step adds purple and light blue to the screen.

< map 10>

< map 11>

< map 12>

4, the creation of optional color adjustment layer, red, yellow, green, cyan, magenta, white, black adjustment, parameter settings such as Figure 14-20, the effect is shown in Figure 21. This step is to fine-tune the image's layering.

< map 14>

< map 15>

< map 16>

< map 17>

< map 18>

< map 19>

< map 20>

< map 21>

5, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Press CTRL + Shift + U to color, blending mode to "multiply", opacity to: 40%, alt key to add layer mask, with white brush to darken the part to wipe out, the effect of the following figure.

< map 22>

6, a new layer, stamped layer. Execution: filter > Blur > Gaussian blur, the value is 5, after the layer blending mode is changed to "soft light", the opacity to: 30%, the effect of the following figure.

< map 23>

7, a new layer, fill pink: #FB8B9F, blending mode to "filter", hold down the ALT key to add a layer mask, with a white brush to the upper left corner of the section, and then properly reduce the opacity of the layer, the effect of the following figure.

8, create curve adjustment layer, appropriate to the whole darkened a bit, parameter settings such as Figure 25, the effect is shown in Figure 26.

< map 25>

< map 26>

9, a new layer, stamped layer. Go to color and hold down the ALT key to add a layer mask, with a white brush to the need to darken parts, the effect of the following figure.

< map 27>

Finally adjust the details and colors to achieve the final effect.