Manual Ghost Installation System tutorial

On the U disk to start more and more popular today, the optical drive gradually fade, more and more friends began to try U-disk PE installation system, but accustomed to the CD-ROM automatic ghost friends face Pure E-Ghost software often feel at a loss, plus often heard that the manual ghost error, Will cause the entire hard drive data to be lost, can only be deterred.

In fact, manual ghost is very simple, correct operation is not what the problem, under PE, open the Ghost program

Press any key to enter the ghost operation Interface, the Ghost menu, we now only use the local menu items, there are three subkeys: disk (hard disk backup and restore), Partition (disk partition backup and restore), check (hard drive detection), We only need to use the partition option to install the system manually Ghost

The partition menu has three submenus below:

1.To partion: Copy one partition (called source partition) directly to another partition (target partition), note that the target partition space cannot be less than the source partition when operating

2.To Image: Backup a partition as a mirrored file, note that the partition that holds the mirrored file is not smaller than the source partition, preferably larger than the source partition

3.From Image: Restores the partition from the mirrored file (restores the backup partition). This is the option we use to manually install the system, notice and 2 difference.

Having learned these, we started the Ghost installation system operation:

1. After the Ghost main menu appears, use the cursor direction key to move to the menu "Local-partition-from Image", and then enter. This step must be careful not to select the "Disk" option, otherwise the hard disk partition table is destroyed ...

2. The "Mirrored File Restore Location window", where the full path and filename of the mirrored file is entered at file name, now most ghost programs support mouse operation, locate to restore the system backup or to install the system Gho file, and then enter.

3. Appear from the mirror file select the Source partition window, direct return.

4. Also appear select local hard Drive window, and then enter.

5. The selection from the hard drive to select the target Partition window, we use the cursor key to select the target partition, that is, to install the system's letter, to determine the return.

6. There is a question window, select Yes enter OK, ghost start to restore the partition information.

7. The familiar Blue progress bar interface appears, waits for several minutes, appears restores completes the window, chooses resets computer to return the computer.

At this point, the installation system is complete.