Mass production U disk boot not successful how to do

The main control UT165, the mass production 2G u disk in the new motherboard and the laptop start all normal, also successfully installed XP Vista Windows 7 and other systems, the results in the 845GV motherboard is always unsuccessful, in this motherboard BIOS setup is very rich, USB-FDD USB-HDD Usb-cdrom Usb-zip these support u disk boot. As a result, you will not be able to start a USB disk for each setting, and select the first, second, and third sequence of devices to be installed in the items [Device], [Second boot Device], and [third boot Device]. Have failed.

Be prepared to take out the disc system when it is not possible to install it. Go into the BIOS again with the last hope and watch carefully. Opened a boot other Device (disable), I turned it on (enable) and set the first Boot Device to Usb-cdrom (in fact, the other two items were all set Usb-cdrom to make no mistake. Results after restarting the computer, accidentally found into the U disk System. Happy ing then to manually enter the PE run GHSOT directly to install the system successfully!

Oh, that's it! These are actually the things that you can see when you look at them more. At the same time in the volume production U disk when I did not change the USB boot of course, directly press A or one installation is absolutely wrong. The reason altar brothers all say quite a lot, my practice is direct advanced PE system then call Ghost for system installation. No problem. There is the partition I very like in DOS using the FDISK command, format for formatting operations, a configuration of the computer hard disk so that all operation completed. Well, I hope the above articles are enlightening to our friends!