This tutorial is based on MAXDOS V6 PXE (integrated with the mini DHCP server TFTPD32 and ghostsrv, and the parameters have been set, that is to say, the technology in this tutorial requires the software (the software has been modified and encapsulated, and the software has not been officially released) and can be downloaded online. After the download is complete, install it. You don't need to talk about the installation process.
I. Server Side settings
1. The server must start two software, TFTPD32 and ghostsrv.
2. Change the IP address of the server Nic to 10.1.1.1, and set the subnet mask to 255.0.0.0 (same as the setting method in the previous article .)
3. Run TFTPD32 and click the DHCP server, as shown in figure
TFTPD32
We can see that the starting IP address, number of dynamic IP addresses, Startup File Name, WINS/DNS server, and so on have been set. We don't need to set it any more and can directly use it.
3. Run GHOSTSRV and set and maxdos as shown in Figure
Ii. Client
1. Start the client and enter CMOS (BIOS). Set the preference to start the network. Save and restart the client.
When the client starts from the network, it will automatically search for and connect to the server, as shown in figure
Start the client
Indicates that the startup file has been connected to the server. Wait a moment and the Startup file will be successfully run, as shown in figure
Client menu
At this time, the system does not connect to the GHOSTSRV server, and only connects to the TFTPD32 service to run the Startup File.
We chose "B" for online engraving. After you press "B", the system automatically searches for the online engraving drive and enters the online engraving menu, as shown in figure
Online menu
If it is a full backup, select the first partition and the second partition (this is not nonsense, everyone on the Earth knows, huh, huh)
The overall interface is as follows:
Full Interface
Press enter to start connecting to the GHOSTSRV Server
C connected to S
Indicates that the connected client has been connected to the server, and the connected client can also be seen on the server.
S connected
Click send to send data. For example
S send data
The data reception interface of the client is shown in figure
C accept data
So far, all operations have been completed, smoke, drink a cup of water, and so on after the data is sent. Haha.
Note that the GHOST file must be in the FAST format, otherwise it will not succeed.
If you have a need for Maxdos v6 pxe Installation File or instructions, you can mail: shooa@msn.com