I have had a Mercedes diagnostic machine
MB STAR C3For a while and I decided to try and make it work, but every time I try to communicate with the car I get a error MESSAG E saying:
Fault (1.1) -1.501.9504
Initialization of diagnosis Multiplexer failed. Possible causes:the link between the diagnosis multiplexer and the diagnostic socket is interrupted. The link between the diagnosis Multiplexer and the diagnostic unit is interrupted. The voltage supply at the diagnostic socket (circuit + (or) circuit) is faulty.
Error Codes analysis:error Code 95XX:C3 MUX Settings is committed
Error code 9551:means no C3 MUX is connected
Error code 9504
:
means
Star
C3
is connected and error in MUXError code 9500:means C3 is connected and error in COM settings to COM2
Error code 99xx:means C4 MUX Settings is committed
The error is 9504 means mux are read by software and MUX are burned but C3 Mux are working on 3 main communication objects :
1-canbus
2-k-line
3-l-line
Your mux may still work if one circuit are burned like CanBus circuit burned but still you had other 2 working on K-line a nd l-linedetailed possibilities of unsuccessful communication:1 COM port setup improperly or broken COM serial on the LAPT OP2 New models that old STAR C3 cannot support3 Something wrong with C3 diagnostic mux4 Something wrong with cables Thus, Mbstarshop advice is to check your mux in other laptop, OR your may find your COM serial on your laptop are broken OR do opp Osite Check other mux on your laptop to find what's wrong. If all is OK, which is the occasions:1 of the model cannot not being supported by Star C3 and you should buy possible
SD Connect C42 The software can not run OK and can try NewV2016.5 MB Star C3 softwareDisclaimer:try on YOUR OWN risk!http://blog.mbstarshop.com/2016/07/28/solve-mb-star-c3-das-fault-1-1-1-501-9504/
MB Star C3 DAS Fault (1.1) -1.501.9504 (Solved)
