Mercury[mw150uh (Drive-free)] How do I set up the analog AP?

The analog AP is also called Softap. When the wireless card is set to the soft AP, the computer using the NIC is equivalent to a wireless router that provides a wireless network. Mobile phones, notebooks and other wireless terminals connected to the soft AP wireless signal can access the Internet.

This article instructs the Mw150uh (drive-free version) to be set to Softap method.

Software can be officially downloaded

1 , turn on the analog AP

After the installation configuration software is complete, open the Mercury client application, click on the analog AP, Softap mode Select Open, click Confirm Open Soft AP mode. The following figure:

After waiting a moment, the system prompts for a successful analog AP configuration. At this point you can see that the default SSID is SOFTAP and the password is 12345678, as shown below:

2 , setting up the analog AP

Select the corresponding network connection in the Internet Connection Sharing drop-down box (for example, the local connection is the actual application). In the Network name and security key to modify the Softap wireless name and password, click Apply , the following figure:

Note : There are multiple network connections in the Internet Connection Sharing drop-down box, as shown in the following figure:

Prompt to configure Softap mode success , click Confirm , as shown below:

At this point, the analog AP Setup was successful and the wireless client could connect the analog AP signal to the Internet.