Modify and bidirectional synchronization of component labels in pads

First of all, I will briefly describe "bidirectional synchronization of component labels", which refers to modifying the component labels in the schematic diagram and then updating them to the PCB diagram, or modify the component label in the PCB diagram and update it to the schematic diagram.

1. Modify the component label in the schematic diagram and update it to the PCB diagram:

1.1 create a new PCB File Based on the schematic diagram, and synchronize the net list. After confirming that the package has been imported into the PCB diagram, proceed to the next step;

1.2 pads logic does not seem to be able to automatically reorder and name existing component labels in batches. You only need to modify each component one by one and then update it to the PCB diagram.

Operation: After modifying the component label in the component properties, run

Tools-> pads layout link-> Design-> ECO to PCB.

The changed component labels and other information are successfully updated to the PCB diagram.

2. After modifying the component label in the PCB diagram, update and synchronize to the schematic diagram:

2.1 create a new PCB File Based on the schematic diagram, and synchronize the net list. After confirming that the package has been imported into the PCB diagram, proceed to the next step;

2.2 In the PCB diagram, You can automatically rename the component labels in batches:

Run the "eco toolbar"-> "OK"-> "auto Renumber"-> "OK" command to set the prefix and name of the component to be renamed.

2.3 After the previous step, the corresponding component labels in the PCB diagram have been renamed. to synchronize the new component labels to the schematic diagram, you must first return the corresponding schematic and execute:

Tools-> pads layout link-> Design-> eco
FromPCB.

-End-