Modify the IP address of the arm Development Board

To modify the IP address of the arm Development Board, if it is a yaffs2 file, you can

1. First, modify the/etc/init. d/RCS file in/sbin/ifconfig lo 127.0.0.0.

Add one/sbin/ifconfig eth0 192.168.1.20 up

Note: 192.168.1.20 is just an example. You can change it to the IP address you want to modify.

I can do this after modification, but I found that it still does not work. Using the ifconfig command, I found that the IP address of the Development Board has not been changed.

Later, I had no intention of inserting a plug-in and found that I had to modify another one.

2. Modify/etc/eth0-setting

Change the IP address to the IP address you want to set.

Restart the Development Board and run the ifconfig command to find that the IP address has been changed.