Notebook T60 Disassembly, installation memory, such as graphic tutorials _ Hardware Maintenance

1 Disassembly tool only need one, is the smallest screwdriver, of course, the most professional to use "clock up." If the tools are limited, this one will do the same. But the dust removal process will remove the fan, so also have to prepare the lubricating oil (fan-specific, I am looking for friends with the motor engine lubricants), GUI juice (because the fan is removed, Will remove the heatsink from the cpu/gpu/motherboard core piece)

2) up the screws, note that. Before the screws, you basically have to put (CD-ROM, hard disk) first removed, on the one hand, dust thoroughly, on the other hand, when the surrounding is easy to disassemble. The Green small Circle is the "palmrest" and "keyboard" need to remove the screws, a total of five.

3, the palmrest should be lifted up from the edge of the keyboard, gradually removed, when you see the red circle part of the touch chain wiring, you can gently pinch up. Remove the palmrest completely.

4 If you want to add memory, you can do this step. The red circle part is not a memory slot. By way of legend, gently lift the keyboard.

5 after the keyboard set off, the same need to open the chain wiring. The method is similar to that of the palmrest, but the strength is lighter, the extension handle is lengthened, and it is pinched (this argument is to be removed from the machine)

6, a part of the online diagram, to do this step, thought that the dust can be carried out, but it is not. Dust removal is a perfect way to remove the fan for cleaning. So, if you want to clean the interior carefully, it is now necessary to take out the surrounding.

Take out surrounded a bit complex, at least the resources on the web is not very rich, and stingy (many forums need to register, super despise) I spent two hours of research.

Green is the one we want to take out (unprofessional), blue, is the key point to remove. This metal piece is connected, so be sure to screw it up.

The green mark on the red circle is surrounded by the buckle, need to gently set off., and then the whole downward removal. (such as legend)

If you need to remove the fan, you must have a red circle in the body labeled screws.

7, there is no suspense, you should pay attention to. The red block in the three key heat dissipation locations are original GUI juice (silver-gray), may be too Chen Jiu, will be bonded together, in the removal, the need to use the skillful force of light shift, after release, can be completely lifted.

8), the network has a professional demolition machine, the award fan complete decomposition and then dust, that's the best way to do it, but you need to destroy some clogged sponges. I didn't use it as a step. Because my machine is still very new, just remove the noise in order to grease. So the cleaning of the fan, spent two hours, with a small brush, little hook, The vacuum cleaner cleaned up, and ran to a friend there on the "legendary" 12,001 bottles of engine lubricants (I do not understand, I do not understand. Just don't know what oil is good ... Blind to the whole).

After the dust is finished, open the most gorgeous category of the game. Air Volume 10 make, mute ... Just like the new machine ... Born Again ~ ~ ~