Optical fiber settings of youxun vro

Youxun vro's optical fiber settings many netizens use fiber-optic access for broadband. They do not know how to set up routers. This article uses the D-Link vro as an example, the basic configuration, Security Service, and P2P settings in the optical fiber settings are described in detail. 1. Optical Fiber-Optic converter-Proxy Server-computer. 1. ADSL/VDSLPPPoE: the dial-up software is run on the computer. Fill in the account and password provided by the ISP. Dial up before accessing the Internet each time. 2. static IP: ISP provides you with a fixed IP address, subnet mask, default gateway, and DNS. 3. Dynamic IP Address: The TCP/IP attribute of the computer is set to "automatically obtain IP addresses". You can access the Internet each time you start the computer; 4. 802.1X + static IP: ISP provides fixed IP addresses, dedicated dialing software, accounts and passwords; 5. 802.1X + Dynamic IP: ISP provides dedicated dialing software, accounts, and passwords; 6. WEB Authentication: Open the Internet Explorer before accessing the internet, specify the ISP's home page, and enter the user name provided by the ISP. Ii. basic configuration (1) set the IP address of a computer and the router management address in the same network segment, enter the router management IP address in the IE browser, and the default username and password of 192.168.0.1 is admin, go to the settings page. (2) to enable automatic dial-up for the vro, enter the ADSL account and password in the vro, click the Home Page label on the top, and then click WAN. You can see the place where the ADSL account is set at PPPoE, enter your own ADSL account and password and save the settings. Now, go to the System Information Section in the system status tab to check the network status. On the WAN side, you can clearly see the network information obtained by ADSL dialing. (3) After configuring the ADSL account, you can access the Internet through the Broadband Router. Click the home page, select DHCP on the left, and set the ip address range in the ip address range that the DHCP server can access, after saving, the optical fiber router settings can automatically assign IP addresses. Www.2cto.com 3. Security Service (1) when using a computer to access the Internet, it is exposed on the network. hackers and viruses may exploit the vulnerability to attack the computer, we can solve this problem by setting up a virtual server. log on to the Broadband Router settings page, select the virtual server on the Advanced Settings page, activate the virtual server settings, and enter the relevant virtual server information. (2) assume that the computer 192.168.0.110 is allowed to provide the ftp service, but other ports are expected to be protected by the vro, you can simply virtualize the ftp service and set the personal IP address to 192.168.0.110, the Protocol mode is tcp. The ftp service uses the tcp protocol and the individual port is 21. You can also set the time period for the vservice to take effect. 4. P2P software (1) as long as it is connected to a vro computer, the use of p2p software will be affected. In this case, you can set a DMZ host to solve this problem, the host set here is exposed in the network and bt software can be used for downloading, but the security of the computer is not guaranteed. Therefore, the security of the computer must be well done. (2) The filter tag on the vro setting interface filters the source and address of the datagram, including IP address, url Information, mac address, and region information, set activation IP address filtering, enter the IP address within the IP address range, and fill in the port information. Because P2P download uses ports 6881 to 6889, We can filter them here, select tcp as the protocol to set the effective time of the filter. The above is the configuration of the optical fiber router. You must know how to set the router when using the optical fiber!
This article is from