ORA-00911: Invalid character error

ORA-00911: Invalid character error--a small error that caused the build environment

Implement a feature script statement. Compile, there was a ORA-00911 error, there are some doubts, before the production library use is no problem, after a few checks found that the original is a very small place error occurred. A simple example of an experiment is simulated below.

Repeat in a simple way:

(Note: It appears at this time????? Garbled, it is necessary to adjust the character settings, not related to this experiment, but because it does not affect the experiment, temporary treatment, treatment methods can be seen there is an article: Click to open the link)

watermark/2/text/ahr0cdovl2jsb2cuy3nkbi5uzxqvahvhbmd5yw5sb25n/font/5a6l5l2t/fontsize/400/fill/i0jbqkfcma==/ Dissolve/70/gravity/southeast ">

Note the semicolon format problem

Remove the semicolon, query again, such as the following, correctly run the

watermark/2/text/ahr0cdovl2jsb2cuy3nkbi5uzxqvahvhbmd5yw5sb25n/font/5a6l5l2t/fontsize/400/fill/i0jbqkfcma==/ Dissolve/70/gravity/southeast ">

Troubleshooting reasons: The input format should be noted that the semicolon should be in English format, or compile error.

Experiment again, and enter the semicolon into the English format, for example, the following. It went through.

*********************************************** declaration ***************************************** *******

original works. From the "Blue Blog" blog, Welcome to reprint, please be sure to indicate the source (http://blog.csdn.net/huangyanlong).

There are errors in the presentation. Please leave a message, greatly appreciated.

*************************************************************************************************** **

Copyright notice: This article Bo Master original articles, blogs, without consent may not be reproduced.

ORA-00911: Invalid character error