Abstract
This article describes how to crack us II 6.0.
Introduction
Step 1:
The following section uses quartusii60_helper.zip.
Step 2:
Sys_cpt.dlland alterad.exe should be written to c: \ Altera \ quartus60 \ win
Step 3:
Set license. dat license to c: \ Altera, use license. when dat is enabled, change hostid = xxxxxxxxxxxx to the physical address of your network card. Note that the address does not contain dash (-), contains numbers and English letters, and is saved after modification.
How do I know the physical address of the network card?
Start-> set-> append application-> command prompt character
When ipconfig/All is input, the following information is output, and the colored part is physical address (different for each computer ).
Fig.1 physical address
Step 4:
Us II indicates that the license has not been set and specify Valid license file is selected.
Fig.2 license setup required
If this interface is not displayed, after entering Quartus II, select tool> license setup.
Next, a window appears.
Fig.3 tools-> options-> license setup
Specify the location of your license file (license. dat). The setting is successful only when the content in the lower colored circle appears.
Step 5:
Reinitialize Quartus II. If the dialog box in Figure 2 is not displayed, the license is successfully set.
Remark
Upgrade to Quartus II 6.0 SP1.
See also
(Original hacker) how to crack Quartus II 6.1? (IC design) (Quartus II) (nioii)
(Original hacker) how to crack Quartus II 7.1? (IC design) (Quartus II) (nioii)
(Original) how to crack Quartus II 7.2 SP1? (IC design) (Quartus II) (nioii)
(Original hacker) how to crack Quartus II 7.2 SP3? (IC design) (Quartus II) (nioii)
(Original) how to crack Modelsim-Altera 6.1g and Modelsim se 6.3e? (IC design) (Modelsim)
(Original hacker) how to crack Quartus II 8.0? (SOC) (Quartus II) (nio ii)
(Original hacker) how to crack DSP Builder 8.0? (SOC) (DSP Builder) (MatLab)
(Original) how to crack Quartus II 8.0 SP1? (SOC) (Quartus II) (nio ii)
(Original issue) how to crack DSP Builder 8.0 SP1? (SOC) (DSP Builder) (MatLab)