Packet Tracer6.0 Static Routing, rip routing, ospf routing configuration, tracer6.0ospf

Packet Tracer6.0 Static Routing, rip routing, ospf routing configuration, tracer6.0ospf

OSPF Dynamic Route configuration Scheme

First, we cleared the RIP configuration information configured in the router in the previous article. R1.R2. R3 cleared the RIP configuration in the previous article according to the method.

-------------------------------------

To configure ospf, we need to go to the command line. We haven't used the command line for configuration before, but configured the Ip address and route table visually,
For the convenience of new users, we only configure the ospf information through the command line, and the port Ip is faster through visual configuration.

--------------------------------------

Follow the steps shown in the figure to enter the vro command line configuration method

------------------------------------

First, we need to know that when we enter the command line, we are in the user mode, such as the above Router> after the '>' symbol represents the current user mode
There are three modes in total

1. User Mode Router> the previous Router represents the vrouter name. You can set it by yourself.
2. Privileged mode Router # Enter
3. Configuration Mode Router (Config) # enter the configure terminal command in privileged mode. The configuration of vro information is generally configured here.

-------------------------------------

1. enable from user mode to privileged Mode

2. Switch from privileged mode to configure terminal Mode

3. Open the router ospf configuration and assign the process id router ospf 1

4. Configure ospf route table information network segment anti-mask area number

The region number is used to separate the use range of ospf. Multiple isolated networks may use the Ospf scheme at the same time.

After the configuration is complete, enter the end command and press enter to save the configuration.

----------------------------------

R2 OSPF route information configuration

--------------------

Ospf route configuration information of R3

--------------------------------------

We can see that we successfully passed the PC0 host pingPC1 host

-----------------------------------------

In privileged mode, you can enter show ip route to view the route table of the current vro.

We can see that the route records starting with "O" are the route table records automatically added by the ospf Algorithm Scheme.