Photoshop filters to create brilliant beam photos

The effect diagram looks very complex, in fact, there are some of the simplest graphics overlay composition. And these small shapes are all done by filters. The whole effect starts with a halo effect, and passes through multiple filter variants to get the results you want.

The effect diagram looks very complex, in fact, there are some of the simplest graphics overlay composition. And these small shapes are all done by filters. The whole effect starts with a halo effect, and passes through multiple filter variants to get the results you want. And then the resulting graphic deformation and combination of many times, and add a gorgeous color, a very visual effect came out.

Final effect

1, new file, size customization, determine the color mode.

2, please be habitual to the layer to do inverse and new layer.

3. Fill the new layer with black and perform "filter"-"Render"-"lens flare".

4, the parameter defaults, the effect is as follows figure.

5, add "filter"-"twist"-"twist" to the current flare.

6, adjust the parameters to about 245, this parameter is dead, mainly to the halo distortion.

7. Add "Filter"-"twist"-"wave" to the distorted image to add details.

8, this parameter should be carefully set, the main adjustment of the top two command parameters can be.

9, observe the effect of adding waves. The distortion of the layer is good, but some places are too far-fetched.

10, change the current Halo transformation layer Blending mode to "filter Color".

11, the image to adjust a little bit and add a mask, observe the edge found Gray edge, so in the future of the compound will have edge resection suspicion.

12, select the brush, and smear the edge, the mask status is as follows.

13, "Ctrl+j" copy the current layer to the new layer.

14, "Ctrl+t" to perform a free transformation, "rotate 90 degrees (counterclockwise)."

15, after the completion of the previous step, press and hold "Shift+ctrl+alt", press "Ctrl+t", on the implementation of the last transformation, the execution of two times.

16, the effect is as follows.

17, the current changes in graphics (in addition to the background) to merge, copy a copy and rotate a number of the following figure, note that here the layer blending mode or filter color. There are problems when we merge layers with masks and mixed patterns.

18, add a color image layer, to adjust the color of the photo.

19. Change the color layer blending mode to soft light.

20, add a "color level" adjustment layer, adjust the parameters themselves to see, there is no dead parameters.

21, continue to add some details, complete the effect.