The picture increases the rays will often use, the process is also relatively simple: first adds the warm color to the picture, then replaces the material sky part with the appropriate light material, and then adds the high light and the dark part to the picture by the light source position and the backlight area;
Original
< small map view big picture >
Final effect
< small map view big picture >
1, open the material picture, create the optional Color adjustment layer, adjust the green, parameters and effect as shown below. This step darkens the green in the picture.
< map 1>
< map 2>
2, create an optional color adjustment layer, yellow, green, white, neutral color adjustment, parameter settings such as Figure 3-6, the effect is shown in Figure 7. This step mainly turns yellow into orange red in the picture.
< map 3>
< map 4>
< map 5>
< map 6>
< map 7>
3, create curve adjustment layer, the RGB, green, blue channel adjustment, parameters and effect of the following figure. This step deepens the darker color of the picture and increases the bluish violet.
< map 8>
< map 9>
4, create a color balance adjustment layer, the shadow, highlight adjustments, parameters and effects of the following figure. This step mainly adds blue to the dark part of the picture.
< map 10>
< map 11>
< map 12>
5, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Enter the channel panel, copy the blue channel, and get the blue copy channel to handle the blue copy channel. Press CTRL + M to adjust the curve, increase the contrast of light and shade, and then smear the parts outside the sky black.
Ctrl-click the blue Copy channel thumbnail to load the selection, as shown below.
< map 13>
6, click the RGB channel to return to the Layers panel, add layer mask to the current layer, the following figure.
< map 14>
7, open the cloud material, drag in, adjust the position and press CTRL + ALT + G to create a clipping mask, as shown below.
< small map view big picture >
< map 15>
8, create curve adjustment layer, to RGB, green channel adjustment, parameter settings such as Figure 16, determined after the same method to create a clipping mask.
< map 16>
< map 17>
9, the cloud layer to copy a layer, press CTRL + Shift +] Top, hold down the ALT key to add a layer mask, with a lower transparency of the white soft brush to the edge of the sky with variegated parts, the effect of the following figure.
< map 18>
10, create a new layer, blending mode to "soft light", the foreground color set to Orange: #EE8352, with a brush to the next picture of the trees painted the front of the scene to increase the sun effect.
< map 19>
11, press CTRL + J to copy the current layer, blending mode to "overlay", add layer mask, with a black brush to erase some too obvious place.
< map 20>
Classification: