Photoshop to create fantasy dark blue forest character pictures

The footage was pretty good, just a little messy. When dealing with the first use of color palette to turn the main color to blue, and then the bottom and corner parts of the dark, so you can better highlight the characters, and then the overall soft treatment, high light area to deal with a dream point can be.

Original

Final effect

1, open the material picture, create hue/saturation adjustment layer, the whole map, red, yellow, green adjustment, parameter settings such as Figure 1-4, the effect is shown in Figure 5. This step quickly turns the main color of the picture into Cyan Blue.

< map 1>

< map 2>

< map 3>

< map 4>

< map 5>

2, create curve adjustment layer, green, blue channel adjustment, parameter settings such as Figure 6,7, the effect is shown in Figure 8. This step adds blue purple to the dark part of the picture.

< map 6>

< map 7>

< map 8>

3, press CTRL + ALT + 2 to bring up the high light selection, press CTRL + Shift + I to select the dark selection, then create the curve adjustment layer, the RGB, blue channel adjustment, parameter settings such as Figure 9, the effect is as Figure 10. This step increases the dark contrast and adds blue.

< map 9>

< map 10>

4, create a solid color adjustment layer, color set to dark blue: #1C092C, to determine the mask filled with black, with a white brush to the bottom to deepen the part of the wipe out, the effect of the following figure.

< map 11>

5, press CTRL + ALT + 2 to bring up the high light selection, create a new layer fill light blue: #8197BE, the blending mode is changed to "multiply" and the opacity is changed to: 50%. Hold down the ALT key to add a layer mask and wipe the white part with a white brush, as shown below.

< map 12>

6, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Press CTRL + ALT + 2 to bring up the high light selection, and then press CTRL + J to copy the selection part of the image to the new layer, blending mode to "color Dodge" and the opacity to: 50%.

Hold down the ALT key to add a layer mask and use a white brush to rub out the parts that need to be lit, as shown below.

< map 13>

7, the creation curve adjusts the layer, the dark part deepens, determines after the mask fills the black, then uses the white brush the bottom and the bottom corner part to rub out, the effect is like Figure 15. This step deepens the bottom area.

< map 14>

< map 15>

Classification:

• PS Image Processing