Original artwork (material from the network)
Effect chart
The specific production steps are as follows:
1, use PS to open the material picture, duplicate one layer (nurturance good habit) Adjusts the image resolution size (Image > Image size), I personally like to adjust the figure to 300 resolution size
2. Use Curve tool to lighten the whole
3, filter, noise, median value of 8 (see Personal habits, general 5-8)
4, color palette, the use of alternative colors for rendering, the value is as follows.
5, after mixing, we save the PSD file, and then open in the Sai inside, with the airbrush brush, choose color, the background paint off
6, use the Watercolor pen tool to the face not smooth place, smear again.
Watercolor pens are set as follows
7 new layer, we began to draw the eyes
Use the Eyedropper tool to draw the eye, a little deeper, and draw the upper eyelid
And then draw the double eyelid to deepen a little to draw the eyelid (note, the double eyelid is not a line, there is thickness)
The lower eyelid is the same as the upper eyelid.
Draw the eye on the eyelids
Draw the whites of the eyes, then raise the white point, drawing the Whites
Draw the eyes of the hair and the background to paint the pupil
Point on all kinds of high light, and refine the whole
Select the pen to set the following, draw the eyelids and draw eyelashes
So the eyes were drawn and finished. (another eye) 8, draw eyebrows, directly draw a little more than a wink to deepen, a simple outline of a few strokes can be
9. Draw Nose
Draw the nostril color choose the darker point of the wink
Choose a slightly brighter eye than a skin wink to outline the edge of the nose
Finally, the nose and the light.
10. Draw Mouth
Draw the eyes of the mouth deepen, sketch the lip line
Highlight (PS: When drawing the mouth, I also got the PS to adjust the mouth color)
10 Draw Hair Select the pen special brush, set as follows
According to the hair trend smear hair, dark darker, lighter light (when drawing hair to draw the messy point, not too rigid)
Create a new layer, mix mode to select the Glow mode, and gently brush the previous high light with the airbrush
Create a new high light layer again, with a pen special brush to draw a thin hair, point to small high light point can
Simple sketch of the rabbit's ear decoration.
Roughly finished, and finally put in the PS of various adjustments
Category:
- PS Getting Started Tutorial