PS Channel replacement to make a beautiful blue-purple location of the picture tutorial

Original artwork before using PS processing

< small map view big picture >

Final effect

1, open the material picture, create an optional color adjustment layer, the yellow adjustment, parameters and effect of the following figure. This step adds a warm color to the picture.

< map 1>

< map 2>

2, press CTRL + J to copy the current optional color adjustment layer, the effect of the following figure.

< map 3>

3, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Enter the channel panel, select the green channel, press CTRL + A all, press CTRL + C to copy, select the blue channel, press CTRL + V to paste. Point RGB channel Return to the layer panel, the effect of the following figure.

4, create an optional color adjustment layer, red, green, white, black to adjust, parameter settings such as Figure 5-8, the effect is shown in Figure 9. This step turns the red in the picture into orange and blue.

< map 5>

< map 6>

< map 7>

< map 8>

5, create curve adjustment layer, RGB, blue channel adjustment, parameter settings such as Figure 10, the effect is shown in Figure 11. This step appropriately increases the brightness of the picture, and the dark part adds blue.

< map 10>

< map 11>

6, press CTRL + J the current curve adjustment layer copy one layer, the opacity to: 60%, the effect of the following figure.

< map 12>

7, create optional color adjustment layer, red, white to adjust, parameter settings such as Figure 13,14, the effect is shown in Figure 15. This step mainly adds light blue to the picture's High light section.

< map 13>

< map 14>

8, create curve adjustment layer, RGB, green, blue adjustment, parameter settings such as Figure 16-18, the effect is shown in Figure 19. This step mainly increases the brightness of the picture.

< map 16>

< map 17>

< map 18>

< map 19>

9, the creation of optional color adjustment layer, red, blue, white adjustment, parameter settings such as Figure 20-22, the effect is shown in Figure 23. This step mainly turns blue to blue purple in the picture.

< map 20>

< map 21>

< map 22>

< map 23>

10, create a color balance adjustment layer, shadow, midtones, high light adjustment, parameter settings such as Figure 24-26, after the layer to determine the opacity: 50%, the effect of Figure 27. This step is to fine-tune the color of the dark part and the high light portion.

< map 24>

< map 25>

< map 26>

11, the bottom channel to replace the layer to copy a layer, press CTRL + Shift +] Top, hold down the ALT key to add a layer mask, with a white brush to wipe out the face of the characters, opacity to: 50%, and then the curve and so the face slightly brighter, the effect of the following figure.

< map 28>

12, a new layer, stamped layer, with a fuzzy tool to the background part of the noise of the fuzzy processing, the effect of the following figure.

< map 29>

13, a new layer, according to the need to simply add some high light, the bottom can be appropriate to increase the dark angle, the effect of the following figure.

< map 30>

Finally, fine-tune the color to complete the final effect.