PS Channel pull figure to pull flowers

1, Bitmap mode has only one channel, the channel has black and white 2 color levels

2, Grayscale mode of the image has a channel, the channel shows the color from black to white 256 levels of change

3, RGB mode of the image has 4 channels, 1 composite channels (RGB channel), 3 representing red, green, blue channel.

4, CMYK mode of the image consists of 5 channels: a composite channel (CMYK channel), 4 representing cyan, magenta, yellow and black channel.

5, the lab mode of the image has 4 channels: a composite channel (Lab channel), 1 of the Ming component channel, two color component channels.

The following is a case to analyze with you, to see the original image and effect map:

Original:

Effect Chart:

Use the PS Channel to pull the map of the specific operation steps are as follows:

Step one, open the original image, and switch to the channel palette, choose a flower and background color contrast the largest channel, copy it.

Step two, the implementation of the image---adjustment---ctrl+i (), when the flowers become white.

Step three, perform the image---adjust---levels (ctrl+l), drag the Black slider to the right to make the dark area darker in the image, and drag the white slider to the left to make the area brighter in the image.

Step four, hold down the CTRL key and click the blue Copy to load the blue copy into the selection

Step five, select the RGB channel, and back to the Layer palette, press ctrl+j (Put the image in the selection on the new layer).

Step six, the last hidden background layer, flowers are pulled out.

Step seven, and then create a new layer above the background layer to fill the light blue.

Category:

• PS Pull Map Tutorial
• PS Channel Cutout Tutorial