PS hand-painted how to make beautiful eyes

Material map

1. First open the picture of the eye, copy a layer for the layer one, resize the picture, pixel to 300. And then do a little skin whitening color (this too most people will, I will not elaborate, will not ask me).

2. Layer One "filter _ noise _ middle Value", the value is about 8. The end of the adjustment is probably the picture below.

3. Create a new layer, hold down SHIFT and draw a positive circle (that is, the eyeball), fill in the dark Purple (#46005a), Gaussian blur two values, and remove the unwanted parts.

4. Create a new layer, hold down SHIFT and draw a positive circle that is slightly smaller than the eyeball, and then use the Polygon lasso (or pen) and the Ellipse tool to make a selection of the following figure, then fill the purple (slightly lighter than the eye color).

5. Add a mask, the default foreground color and background color, and then pull a gradient as shown in the arrow.

6. The pen along the eyeball end draw a path, the following figure, and then with Dodge tool strokes, check the simulation pressure, 3~5 pixels around, not obvious words can be more than a few strokes.

Then draw a few paths in the position shown below, use the eraser strokes, check the simulation pressure, the value 3~5 about.

7. Create a new layer, add a few high light white dots in the middle of the last smear position.

8. Create a new layer, paint the whole eyeball with the brush, this does not have to do too much explanation. (and then the eyeballs are finished)

9. Create a new layer, put it on top of the layer, tick the whites of the eyes, fill the white, Gaussian Blur 3, opacity 60%.

10. New layer (layer order back to normal, do not build this layer below), with a brush in the eyeball left and right side point two white dots, the value of 5~7 around, and then use the Smudge tool to the middle of some (smear tool value is about 3).

11. Create a new layer, with a pen to check out the line, the foreground color is set to dark purple (#46005a), stroke path (tick simulation pressure).

12. Create a new layer, the pen to check the double eyelid path, color selected purple, stroke path, appropriate reduction of opacity. (check the simulated pressure).

13. Create a new layer, put it on top of the white layer, draw the path of the following figure with a pen, then load the selection, fill the dark purple (#46005a), the opacity to 20% (forgive me this path is too ugly), finish can use eraser to fix the edge slightly.

14. Create a new layer (above the layer above) and use the same method to draw a shadow in the eyelid position. (Everybody draw carefully, don't care about my path)

15. New layer, in the corner of the eye point a white dot, finished painting is like this

16. Create a new layer and highlight it in the place I circled (in fact, I don't really raise the light)

After the brush is finished with the high light

17. Create a new layer, draw the eyelashes, that will only draw a long eyelashes, will not draw a short, and anyway this is not how to see the eyelashes, and then I omitted.