PS Pull up the grass blue and purple non-mainstream beauty pictures

Dark tone blue-red is also a common color. Roughly palette process: first analyze the color composition of the material picture, then keep the warm color of the picture, other colors into blue, and then the overall pressure and increase the dark angle.

Final effect

Original

First, PS open the original material, create an optional color adjustment layer, yellow, green, black to adjust, parameter settings such as Figure 1-3, the effect is shown in Figure 4. This step turns the green of the background part to dark blue.

Second, create curve adjustment layer, red, green, blue adjustment, parameter settings such as Figure 5-7, the effect is as shown in Figure 8. This step adds blue to the picture's dark part.

Third, create an optional color adjustment layer, adjust the white, parameter settings such as Figure 9, the effect is shown in Figure 10. This step adds light yellow to the high light portion.

To create a color balance adjustment layer, the shadow, midtones, high light adjustment, parameter settings such as Figure 11-13, the effect is shown in Figure 14. This step increases the blue of the dark part and the high light portion.

Five, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Blending mode to "multiply", opacity to: 40%, add layer mask, with a black brush to wipe out the middle part, the effect of the following figure. This step increases the dark angle of the picture.

Six, and then create a curve adjustment layer, to adjust the blue, parameter settings such as Figure 16, the effect is shown in Figure 17. This step adds blue to the picture's dark part.

Seven, create an optional color adjustment layer, adjust the red, parameter settings such as Figure 18, determined to use a black brush to wipe out the face of the characters, the effect is as follows Figure 19. This step turns red to orange yellow.

Create a new layer, stamped layer. Simple to the character to rub skin, eliminate some miscellaneous points, the effect of the following figure.

Nine, create brightness/Contrast adjustment layer, parameter settings such as Figure 21, appropriate increase the contrast of the picture, the effect is as shown in Figure 22.

To create a color balance adjustment layer, adjust the high light, parameter settings such as Figure 23, the effect is shown in Figure 24. This step strengthens the color of the high light section.

New layer, stamped layer. Executive: Filter > Blur > Motion blur, Angle set to 45 degrees, distance of 150, after the change layer blending mode to "soft light", the opacity to: 50%, the effect of the following figure.

12, create a curve adjustment layer, appropriate to the whole picture to lighten up a bit, parameter settings such as Figure 26, the effect is shown in Figure 27.

Finally, fine-tune the color to complete the final effect.

Note : More wonderful tutorials Please pay attention to the triple Photoshop tutorial section, triple PS group: 182958314 welcome you to join

Category:

• PS Palette Tutorial
• PS Non-Mainstream tutorial