PS Synthesis Technique Wang's face was changed to Scofield's face.

Star Material 1:

Star Material 2:

Here's a look at the final effect of the face-changing image:

This tutorial is relatively not too complicated, you can adjust the color according to the demo will not be wrong. Now start to get to the point, to change the face of the star's specific steps are as follows:

Step one, at the same time open these two obvious material, select material 1, because we want to change face, so use lasso tool to the material 1 of the face of the selection, here need to pay attention to the details. So the 1-face constituency is finished. As shown in the figure:

Step two, select the selection, and then perform "select-Modify-Feather" on it, and the feather value will probably be set to 2. As shown in the figure:

Step three, after the feather, in the copy selection, drag the selection to the material 2 graphics, in the material 2 to the face of the selection of the Ctrl+t free transformation of the selection, and then to the appropriate edge resize and position, of course, we can also fine-tune the opacity of the face material, the general effect is as follows:

Step four, the material 1 face adjustment, hide its layer, we use the eyedropper tool to the material 2 of the face of the skin to draw over the color of the foreground, where the color parameter is "bf6530." As shown in the figure:

Step five, create a new layer above the material 1 layer and fill it with a foreground color from the previous Eyedropper tool, and set the layer blending mode to color.

Step six, hold down the CTRL key and click on the material 1 layer to get the selection, select the color fill layer, reverse (CTRL + Shift +i), delete. As shown in the figure:

Select the material 1 layer and erase the extra hair and face contour with the soft corner eraser tool. As shown in the figure:

Step eight, select the color fill layer, perform the "image-adjust-curve", drag the Curve bar, where appropriate adjustments to make the effect more realistic. Then use the soft angle eraser tool to erase the color fill layer and the background layer transition part, make the transition more natural. The final effect figure is as follows:

Category:

• PS Composite Picture Tutorial