PS use ' tonal homogenization ' and ' mean ' to color photo

May be a lot of people do not blur in the "average" command and image adjustment in the "Tonal homogenization" command, in fact, each of the commands in PS has its unique, master and use it, for us to deal with photos without a benefit.

The image below the whole of the magenta, to deal with this color is best to give him a rise "temperature", because this photo, the spot light temperature is a bit low, and our camera white balance set too high,

Then we'll raise the picture to "warm" at the end of the period. You know, the blue picture is generally high color temperature, how to get the magenta value of this picture, in the past we used to pick up the color tool in the photo color,

This method is undoubtedly correct, but the novice often do not know the point there, if the wrong place, will be disorderly point "Mandarin duck Spectrum", the final result may not necessarily we want.

PS Fuzzy command has an "average" command, why we do not use it, we get an average, color will generally sorta. We want a reverse-phase photo of the magenta, to mix and neutralize,

To achieve the purpose of correcting color.

The following photo is processed using the "average" and "tonal homogenization" commands.

Tutorial Artwork:

01. Let's first test the original information of this photo: r:148 g:55 b:11

02. After making the fuzzy "average", let's test the photo color information: r:111 g:40 b:11

Compared to the R and G color "mean", and we just tested the point R (Red) G (green) slightly more, B (blue) did not change. Note that the "average" color is correct.

3. Find the average point, then we can increase the magenta outside the color, how to get its inverse color? image/Adjust/reverse, now the information of the photo becomes: r:144 g:215 b:244,

You can see that after the reverse phase, the channel's green and blue information data came up, that is, the channel green and blue increased, the magenta color will be "pressure" down.

04. Now to do is to let PS automatic mixing, we choose Layer mode "color", the photo is blue, that good to do, reduce the layer mix opacity, when the opacity to 45%, feel more appropriate.

05. Feel the picture is a bit dark, image/adjust/tonal homogenization, the image will become brighter, the color is almost the same

06. Again to debug the adjusted picture, r:233 g:185 b:172 photos of the color basically conform to the color law, if you feel a little bit of color, you can also fine-tune, here did not do fine-tuning