PS Webpage Design tips-Quick Design of 3D lattice words

Recently, I am hanging out on the Internet. I found a good tutorial on 3D lattice words. Assign the tutorial to the bottom after you have experienced it yourself. This tutorial is not original, and has made appropriate improvements based on the original.

 

The completed work is as follows:

 

 

Step 1: create a reference template

Create a 20px * 20px document, zoom in to 800%, use the text tool book to write the text "zhu", edge options select none

This is the template for subsequent steps.

 

Step 2: create basic blocks

Do not close the previous document. Create a new document 500px * 500px.

UseRectangle ToolCreate a rectangle with the size of 19px * 19px. Color: # 0a6b8e

Press Ctrl + J to copy the layer and move it to 19px above the source layer. The color is changed to: #2bb3e5.

Copy the layer again and move it to 19px on the left of the source image layer. The color is changed to: #208ab1.

Tilt the rectangle above 45 degrees to the left, press Ctrl + T to change freely, click the control point in the lower right corner, and adjust the H parameter to 45

For the left-side rectangle, tilt up 45 degrees, press Ctrl + T to change freely, click the control point in the lower right corner, adjust the V parameter to 45

Combine the three rectangles into a group named box

Right-click a group and chooseConvert to Smart Object, Named as box

 

Step 3: Place squares according to the template

At this point, the template and the square have been completed, and the next step is to place the square according to the template

 

The placement order starts from the lower right corner of the template to the upper left corner of the template.

Move the box layer to the bottom right corner of the canvas

Press Ctrl + J to copy the layer, select the mobile tool, press shift, and press the left arrow key twice. The new layer moves 20px to the left.

This is also the reason why the size of the square is 19px. The square moves 20 Px to the left, and there is a 1px gap with the previous square, which makes it more stereoscopic.

 

Copy the box multiple times and move it to the appropriate position (SHIFT + direction key, move 10 PX at a time ). If an inappropriate effect is displayed, adjust the order of the layers. As shown in:

 

Step 4: Adjust the proper angle to make it look more realistic

Combine these layers into a group named Zhu

Point group, press Ctrl + T to change freely, and set the value of V to-20.

 

Step 5: Quickly adjust the color

Double-click any layer in the Zhu group to open the editing window.

Adjust the color of each layer, and then close and save. This is the advantage of Smart Objects. When a component is changed, all components change at the same time.

 

Additional note: color settings

Each square requires three colors, which is not a problem for the artist. For those of us, the color settings are a little too tight.

You can easily set the color by using the HSV attribute of the color.

Front color: H: arbitrary; s: 90; V: 55;

Color on the left: H: The same as the front; s: 80; V: 70;

The above color: H: The same as the front; s: 80; V: 90;