Repair notes: Linksys wireless router settings

Many wireless router configurations may cause network connection failures or other faults during wireless Internet access. In this article, we will make a small summary of the Linksys wireless router configuration problem. We hope that the following problems can be solved.

Linksys routes include: WRT54G; WRT54GS; WRT54GC; WRT54G; BEFW11S4; WRTP54G; WRT54GP2A-AT; WRK54G; WRT300N

The following are common examples of Linksys AP: WAP54G; Linksys WAP11; only the wireless platform functions are not supported by ADSL dial-up DHCP)

The factory implicit setting of linksys is that the login name and password are both admin

Wireless Router connection settings

Linksys wireless router configuration 1

Used as a wireless route: (applicable to general homes and environments with only one wireless route)

Method: The original ADSL cat ---> wireless route to the WAN port --> Computer

1. Go to the wireless route management page http: // 192.168.1.1.

2. If you use a wireless route to automatically dial up the Internet, set ADSL dialing in the WAN settings on the management interface.

3. If you want to change to manual dial-up Internet access, change the WAN-configured connection to PPPOE to a fixed IP address.

For example, 192.168. 1.2. Add an ADSL dial-up connection to your computer.

Linksys wireless router configuration 2

Used as a wireless switch: (applicable to an environment where a general company or only has multiple routes or expands a wireless transmitter switch on the original network)

Operation Method:

1. Use a network cable to connect your computer to the LAN port of the wireless route and enter the WEB page of the router. The default value is http: // 192.168.1.1.

Note: if you cannot obtain an IP address or enter the management page after connecting your computer, please manually change the IP address of your computer to 192.168.1.XXX)

2. Connect the network cable from the original neighbor to the LAN port of The LINKSYS Wireless switch.

Method: adsl cat (or leased line access) --> other routers (--> switches) --> note: the network cable from other routers or switches to the wireless router must be connected to the LAN port of the wireless router, that is, one of the four ports ).

DHCP can be disabled to avoid conflicts with DHCP on the original network.

Wireless route settings

After setting the above method, we need to set the SSID and vro name of the wireless route, then your vro will basically run normally.

Linksys wireless router configuration 3

About Wireless route security settings

You can set either of the following methods or both.

1. Set access through a secure password

After setting the route, set WEP in the wireless connection management of the laptop and enter KEY1.

2. Filter by MAC address

Linksys wireless router settings 4

Other settings

1. Route settings

2. Software Upgrade

3. Port ing

Linksys wireless router configuration 5

FAQs

At the beginning, I went in, but now I cannot go in. At the beginning, I went in. I don't know what the password is.

1. You have a RESET behind the wireless router and press configure. 5-8 seconds. If it is still flashing. Turn off the power supply. Open again.

2. Reconnect the wireless route to your computer's wired network cable. Then, use the CD to perform step-by-step operations.

The other method is to use http: // 192.168.1.1 to enter the wireless management interface for setting.