From today on we review together to learn the debugging of routers and switches. Based on the CCNA tutorial, we practice a few small commands every day, and make up a little, and finally become an amplifier.
Enable: Enter privileged mode and the command prompt becomes hostname# after run
Configure Terminal: Enter the global mode command prompt to change to hostname (config) #
Hostname: Naming the device
Exit quit Privilege
No IP domain-lookup: Turn off address resolution, in order to avoid the wrong command, the command as address resolution, delay time
650) this.width=650; "title=" untitled.jpg "src=" http://s3.51cto.com/wyfs02/M02/6C/68/wKiom1VIiN_ Grfozaaocd2du7uq912.jpg "alt=" Wkiom1viin_grfozaaocd2du7uq912.jpg "/>
This article is from the "Guo Yong Technology blog" blog, make sure to keep this source http://guoyong.blog.51cto.com/408495/1642160
Routing switching debug (CCNA) 0 basics to Expert