Download Xshell 5 software to install under Windows
Xshell 5 boot software after installation
Next, check that the virtual machine is configured correctly
Next, set up the network to ensure that the virtual machine system can connect to the network
Next, go to the virtual machine system, check the virtual machine network connection is normal, if not, will link the network, link to the network
Next, after the network is connected properly, open the terminal command
Next, enter "Ifconfig" in terminal to view the IP address of the system
Next, you should be able to see the IP address of the virtual machine, and the gateway, etc. (if you find that the system does not have an IP address, you can set the IP address with the "Ifconfig eth0 IP Address" command.) )
Next, on the Windows Xshell 5 Software link Virtual machine system, open Xshell 5 software, new session
Next, enter the host to be linked, that is, the IP that was found at the virtual machine terminal, and then determine
Next
Next, enter the virtual machine system user name
Next, enter the virtual machine system user password
Next, you'll see that the linked virtual machine is successful
When you're done, you can write all sorts of orders.
Section II Windows system Xshell 5 software remote access virtual machine Linux system