The Tp-link IPC (Network Camera) supports the standard ONVIF protocol, which can be used with the NVR of different vendors that support the ONVIF protocol.
This paper introduces the usage of Tp-link IPC collocation Haikang NVR.
1
, the IPC access network
Connect your IPC, NVR, and client computers to your network. As shown in the following illustration:
IPC and NVR Default IP address are 192.168.1.0/24 network segment, NVR can automatically discover IPC.
2
, Configuring IPC using Haikang NVR
IPC is found in NVR and added to management, and the following is an example of the NVR (DS-7808N-SNH) to introduce the method of adding IPC for management. The following only give examples, specific to the actual use of the NVR model or consult the corresponding manufacturers.
Use the VGA connector to connect the monitor and NVR and log into the NVR GUI interface. In the preview interface, click the right mouse button, open the right-click menu, choose to
add
IP
channel , access to the IP channel Management page.
Click
Refresh to view the IPC that can be added. Click Add IPC, as follows.
Description: You can also add IPC by clicking on it.
Add additional IPC in turn, add complete, and view the connection status of the IPC:
After the successful addition, the preview screen is as follows.
Why do I add the yellow triangle exclamation mark after adding this method?
our
IPC
earlier versions of the software had an activation mechanism, which required
IPC
after you set up your administrative password to add to
NVR
, if there is no advance activation, in the third party
NVR
the failure is added on. So, try the following methods:
method One, please login to the IPC management interface, click on the
information to view the IPC model and software version. Then search the website for the latest software, download and follow the upgrade instructions to the IPC upgrade software. After the upgrade is complete, reset the IPC, and then add the IPC as described above .
Upgrade method Please refer to:
[
security
] IPC
software upgrade method
method Two: if the current is not easy to upgrade, please activate the IPC (set Management password), there are two ways to activate:
1, login to the IPC management interface, set management password and modify the IP address, you need to activate each IPC.
2, download Tp-link security client, unified network of IPC configuration, and then batch activation.
After activation, in the Hai Kang nvr
add the
IPC
channel to remove the channel, be sure to add it by means of the following.
Note: The administrative password for the IPC must be entered correctly, or it will cause an "unknown error".