Many people feel that the creation of the entity is simpler than the surface and the sheet metal, so here are some ways to convert the entity to sheet metal in SolidWorks.
1, here at random to draw a step entity, and create a cut sketch, finished using the conversion sheet Metal command.
2, according to the steps to select the fixed surface and bending line, and then make a cut
3, the width of the incision can be adjusted by a single gap, as shown in the picture
4, after the conversion is completed, such as the figure, note that the opening position can not be selected as bending lines
5, incidentally speaking of the transition order sheet metal, in the need to turn the position of the plate to make a sketch line, as shown in the selection of transition depth
6, the completion of sheet metal after the transition effect as shown.
Note: Cut sketch can not be closed, select the line first must be a fixed surface of a line.