SolidWorks How do I set the bending factor in the sheet metal? Many people in the SolidWorks sheet metal bending when the coefficient to determine inconvenient, in software tutorials related to practical explanation is also difficult to find, in the SolidWorks commonly used in the bending deduction method, ordinary steel plate 90 degrees bend deduction as shown, There may be a difference of 0.1-0.2 depending on the thickness of the plate.
1, in the operation every time to do the setting of the coefficient is very cumbersome, and there are worries forgotten, here can be set with the bending coefficient table, the coefficient table in the installation directory C:Program Filessolidworks Corpsolidworkslangchinese-simplifiedsheetmetal Bend Tables, where my software is installed on the C disk. Open as shown
2, if some people cannot find the installation directory file, you can also select the bending coefficient in the software table, and then click to browse.
3, the same, you can also choose to use the specification table, the specification table for their own needs of editing.
4, in the specification table according to material and thickness requirements set, later in the bending process does not need to repeatedly set parameters, greatly reduce the workload of our design.
Note:
Now many enterprises buy steel plate is thinner than the standard thickness, so these parameters should be as far as possible in the actual processing of the calibration, suitable for their own is the best.